Why Your Wireless Charger Gets Hot: The Physics Behind the Heat

Archi3 min read

wirelesscharginghardware

Contents
  1. The heat is not a side effect. It is the mechanism.
  2. The coupling coefficient
  3. Eddy currents in the wrong places
  4. Conversion losses at every stage
  5. Why the phone throttles
  6. What you can control

The heat is not a side effect. It is the mechanism.#

A wireless charger does not send power through the air like a radio tower. It drives an alternating current through a coil, creating a magnetic field that induces a voltage in a matching coil inside the phone. That coupling is never perfect. Every millimetre of misalignment, every stray metal object, and every conversion stage turns electricity into heat instead of charge. The warmth you feel on the back of your phone is the physical cost of doing this without wires.

The coupling coefficient#

The magnetic field from the charger coil only reaches the phone coil efficiently when the two are close and aligned. The fraction of the field that actually links the two coils is called the coupling coefficient, often written as k. In a well-designed pad with the phone centred, k might reach 0.6 to 0.7. Shift the phone 10 millimetres off centre and k drops quickly. The charger responds by pushing more current to maintain the requested power, and the extra current heats both the coils and the shielding.

Most chargers use a small guide magnet or a visible ring to help alignment, but the tolerance is tight. A phone case thicker than about 3 millimetres can push the coils further apart and reduce k even when the phone looks centred.

Eddy currents in the wrong places#

Any conductive material inside the magnetic field will develop eddy currents. In a phone, that includes the metal frame, the camera housing, and sometimes the battery shield. These currents flow in loops and dissipate as heat. Manufacturers add ferrite sheets behind the receiver coil to steer the field away from sensitive components, but those sheets are not perfect. If a foreign object like a coin or a key sits between the phone and the pad, the field can induce large currents in it. The result is a hot spot that can reach 60 degrees Celsius or more in seconds. Better chargers include foreign object detection, but the feature relies on sensing a change in coil inductance, and it can miss small items or trigger late.

Conversion losses at every stage#

Wireless power transfer is a chain of conversions. The wall adapter converts AC mains to DC. The charger's inverter turns DC back into high-frequency AC to drive the coil. The phone's receiver rectifies the induced AC to DC. Each stage has an efficiency penalty. A typical system delivers about 70 to 80 percent of the power drawn from the wall to the battery. The missing 20 to 30 percent becomes heat. At 15 watts, that is roughly 3 to 5 watts of thermal energy spread across the charger and the phone. At 50 watts, the waste can exceed 15 watts, which is why high-power wireless charging pads often include fans.

Why the phone throttles#

Lithium-ion batteries age faster when they are hot. Charging at high current while the battery is already warm accelerates chemical breakdown. Phone firmware monitors the battery temperature and reduces the charging rate when it crosses a threshold, often around 40 degrees Celsius. That is why a phone on a misaligned charger may show a slow charge even though the pad claims 15 watts. The charger is not lying. The phone is protecting itself.

What you can control#

Alignment matters more than wattage. Centre the phone on the pad and remove thick cases. Avoid charging on soft surfaces like beds or cushions, which trap heat. If the pad has a fan, keep its vents clear. And if you need speed, a cable still wins. The heat is not a defect. It is the physics of moving energy through a gap that refuses to be perfect.

More articles